The former firmware will be recovered in the background. The firmware of your keyboard is now being updated.ģ. The updater shows the Installed Firmware version and the Newest Firmware version. Unzip the downloaded file and run the extracted ' Updater' application.ĥ. Download the Firmware Updater to your computer.Ĥ. Note: if using a KOMPLETE KONTROL S-Series Mk1 keyboard, follow the steps in the next chapter.Ģ. How to Update the Firmware of your KOMPLETE KONTROL KeyboardĮvery time you start the KOMPLETE KONTROL software with a KOMPLETE KONTROL M32, A-Series, or S-Series MK2 keyboard connected, the software checks for available firmware updates and informs you if a new version is available. Now you can restart the Updater to finish the firmware update. ![]() After the process, the screens on your controller will display the MASCHINE logo again. Connect the USB cable or the power supply.ģ. If you accidentally powered the controller off or unplugged the USB cable or power supply during the update process, the firmware update will fail. After the firmware has been updated, click FINISH to close the application. If you're using a power supply, do not unplug it.ĭon't panic if the screens turn black - this is part of the process.Ħ. Do not turn off the controller or disconnect the USB cable. IMPORTANT: This process can take up to 2 minutes. The firmware of your MASCHINE MK3 is now being updated. Unzip the downloaded file and run the extracted ' Updater' application.Ĥ. Download the file MK3_FWUpdater_XXX.zip to your computer.ģ. If you receive the following message, follow the steps below:Ģ. Make sure that the added folder only contains sub-folders and VST files.Every time you start the MASCHINE software with a MASCHINE MK3 controller connected, the software checks for available firmware updates and informs you if a new version is available.Don't add your whole C: or C: > Program Files path.If your plug-ins are stil missing in MASCHINE, please read this article. Find out where the plug-ins are installed and add the path to MASCHINE's plug-in locations as shown above. The above also applies to third-party VST plug-ins. This will happen automatically with each start from now on. Now you can click Rescan to scan the new location.If the VST Location doesn't appear already in the list, click Add, navigate to the location and confirm with Ok. ![]() Open Preferences > Plug-ins > Locations.Close Native Access and start MASCHINE.In this example, the GUITAR RIG 6 VST plug-in is installed in:Ĭ: > Program Files > My Music Production > My VSTs Below VST Location (64bit), you can see where you've installed the plug-in.Click the three dots on the right side and choose Installation Paths.Open Native Access and find your product in the list.If you have installed your VST in a custom folder, the folder path has to be added to the plug-in locations in MASCHINE's Preferences: Note: VST3 files are always installed in the default folder and should not be moved: C: > Program Files > Native Instruments > VSTPlugins 64 bit. ![]() The default installation path offered by Native Access is automatically scanned by MASCHINE: On a Windows computer, VST plug-ins can be installed in any location on your hard drive. If your plug-ins are missing in MASCHINE, please follow the steps in this article. MASCHINE scans these folders at each startup and recognizes any new plug-ins that have been installed.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |